beautypg.com

Configure ethernet interface (reset) – GW Instek GDM-8261A User manual User Manual

Page 144

background image

GDM-8261A User Manual

144

Configure Ethernet Interface (RESET)

Background

The RESET command is used to reset the Ethernet card
when new settings have been made. When the DHCP, IP,

subnet, gateway or DNS settings have been edited, use
the RESET command to validate the changes and reset

the Ethernet card to the new configuration settings. New
Ethernet configuration settings are only updated after the

Ethernet card has been reset.

Ethernet port
configuration

1. Press the Shift key, the 2nd

(Menu) key, the Left key

repeatedly until the SET LAN
configuration menu appears.


Note: SET LAN will only be
available after LAN has been
activated in the I/O menu, see

page 142.

/ EXIT

SHIFT

2ND

MENU

HOLD

2. Press the Down key. The

RESET selection display
appears.

3. Press the Down key. The

RESET YES/NO selection

appears.