GW Instek GDM-8261A User manual - Manual (Page 139)

REMOTE CONTROL
139
Power On Connect the power cord and turn On the power.
Configure GPIB Interface
GPIB port
configuration 1. Press the Shift key, the 2nd
(Menu) key, and then the left key
repeatedly until the I/O
configuration menu appears.
/ EXIT SHIFT
2ND
MENU
HOLD
2. Press the Down key and the
Left key repeatedly until the
GPIB selection display appears.
Note: The GPIB menu will be
selectable only when the GPIB
card is installed.
HOLD
3. Press the Down key. The GPIB
ON/OFF selection appears.
4. Press the Up/Down key to
select ON or OFF.