GW Instek GDM-8261A User manual - Manual (Page 145)

REMOTE CONTROL
145
4. Press the Up/Down key to
select YES or NO. YES will
reset the Ethernet card, NO will
cancel resetting the card.
5. Press the Enter key followed by
the Exit key. The Ethernet card
will be reset after the exiting the
menu system.
AUTO
ENTER
/ EXIT SHIFT
Note
After the exiting the configuration menu, the Ethernet
card will reset. Resetting the Ethernet card takes
approximately 5 to 10 seconds.
The continuity icon (
/
) is used to indicate the status of
the Ethernet card after it has been reset:
/
(flashing): indicates that the Ethernet card is resetting
/
(flashing → turns off): indicates that the Ethernet
card has finished resetting.
/
(flashing → stays on): indicates that the Ethernet
card has finished resetting when the continuity function
is active (see page 38).
Configure Ethernet Interface to DHCP
Background The GDM-8261A supports DHCP to have an IP address
and other configuration parameters automatically
assigned by a DHCP server. If the DHCP server is
absent, the Ethernet card will automatically assign an IP
address between 169.254.1.0 and 169.254.254.255 using
AUTO-IP configuration.
1. DHCP
Configuration
1. Press the Shift key, the 2nd
(Menu) key, the Left key
repeatedly until the SET LAN
configuration menu appears.
Note: SET LAN will only be
available after LAN has been
activated in the I/O menu, see
page 142.
/ EXIT SHIFT
2ND
MENU
HOLD