GW Instek PSU-Series User Manual - Manual (Page 90)

PSU Series User Manual
90
2. Configure T-01 (Run Test) to 1~10
(save memory slot no. to run)
Page 87
T-01 range 1~10
3. The test script will automatically start to run.
Note
Error messages: If you try to run a test script from
an empty memory location “Err 003” will be
displayed on the display.
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
V A
Stop a Test To stop (abort) a running test at
any time, press the Test key. TEST
STOP will be displayed and the
unit will return to normal
operation after a few moments. TEST
Export Test Script to USB
Overview The Export Test function saves a test file to the
root directory of a USB flash drive.
 Files will be saved as tXXX.tst where XXX is
the memory number 001~010 from which
the test script was exported from.
 Files of the same name on the USB flash
drive will be written over.
Steps 1. Insert a USB flash drive into the
front panel USB-A slot.