GW Instek PSU-Series User Manual - Manual (Page 173)

COMMUNICATION INTERFACE
173
2. Press the Function key to enter the
Normal configuration settings.
Page 109
Set the following LAN settings:
F-36 = 1 Turn LAN on
F-37 = 1 Enable DHCP
F-59 = 1 Turn the web server on
F-60 = 0 or 1 Set to 0 to disable web
password, set to 1 to enable web
password
F-61 = 0000
~9999
Set the web password
3. The LAN indicator will turn on when a
network cable is plugged in.
LAN indicator
A V
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
Note
It may be necessary to cycle the power or refresh
the web browser to connect to a network.
Web Server Remote Control Function Check
Functionality
check Enter the IP address of the power supply in a
web browser after the instrument has been
configured as a web server (page 172).
The web server allows you to monitor the
function settings of the PSU.
You can check the IP address by checking F-39 to
F-42.
F-39 = AAA IP Address part 1 of 4
F-40 = BBB IP Address part 2 of 4
F-41 = CCC IP Address part 3 of 4