GW Instek PSU-Series User Manual - Manual (Page 38)

PSU Series User Manual
38
Power Up
Steps 1. Connect the power cord to the
universal power input.
Page 36
2. Press the POWER switch on.
3. The power supply will show the Power On
settings (Pon) at start up. If no Power On
settings are configured, the PSU will recover
the state right before the power was last turned
OFF. If used for the first time, the default
settings will appear on the display.
For default configuration settings, see page 183.
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
V A
Note You may also configure how the PSU will behave
on startup by altering the Power On Configuration
settings, see page 107.
Power Down To turn the PSU power supply off, press the
power switch again (0 position). It may take a
few seconds for the power supply to fully turn
off.
CAUTION
The power supply takes around 8 seconds to fully
turn on or shutdown.
Do not turn the power on and off quickly. Please
wait for the display to fully turn off.