GW Instek PSU-Series User Manual - Manual (Page 65)

OPERATION
65
the isolation voltage of the power supply.
Never connect sensing cables when the output is
on. Electric shock or damage to the power supply
could result.
Note
Be sure to remove the sense jumpers from the
remote sense connector so the unit is not using
local sensing.
Single Load 1. Connect the S+ terminal to the positive
potential of the load. Connect the S- terminal to
the negative potential of the load.
Output
S+
S-
PSU
Output
Load
Input
Input
Page 62
2. Operate the instrument as normal.
See the Basic Operation chapter for
details.
Page 51
Parallel PSU
Units 1. Connect the S+ terminals to the positive
potential of the load. Connect the S- terminals
to the negative potential of the load.