beautypg.com

Interface configuration settings, Usb / gpib settings – GW Instek PSU-Series User Manual User Manual

Page 102

background image

PSU Series User Manual

102

F-14

0 = OFF 1 = ON

Display Memory
Parameter

Displays which memory setting is recalled (M1,
M2 or M3) when recalling a setup.
F-15

0 = OFF, 1 = ON

Auto Calibration
Parallel Control

This function performs offset calibration for
parallel control. There must be a short between
each unit before starting the calibration. See
page 77 for details.
F-16

0 = Disable, 1 = Enable, 2 =

Execute Parallel Calibration and
set to Enable

Measurement
Average Setting

Determines the level of smoothing for the
average setting.
F-17

0 = Low, 1 = Middle, 2 = High

Alarm Recovery
and Output
Status

Set the output status when OHP, FAN and AC-
Fail alarm be cleared.
F-18

0 = Safe Mode, 1 = Force Mode

Lock Mode

When the front panel is locked, the Lock Mode
function determines the behavior of the Output
key.
F-19

0: Lock Panel, Allow Output OFF

1: Lock Panel, Allow Output
ON/OFF

Interface Configuration Settings

USB / GPIB Settings

Show Front Panel
USB Status

Displays the front panel USB-A port state. This
setting is not configurable.
F-20

0 = None, 1 = Mass Storage