GW Instek PSU-Series User Manual - Manual (Page 42)

PSU Series User Manual
42
5. Connect the positive load cable to the positive
output terminal and the negative cable to the
negative output terminal.
6. Reattach the output terminal
cover.
Page 43
Connection
Example Use the included M8-sized bolt set to connect the
load cables to the output terminals. Make sure that
the connections are tight and that washers and spring
washers are used to ensure a good connection.
2-Wire terminal lug
2-Spring washer
2-Hex Nut
4-Flat washer
2-M8x16L SCREW