Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 60)

Survey Pro Reference Manual
R-52
The Level Setting screen is only available when running in leveling
mode. It is used to configure all of the settings for performing a level
loop.
BS1…BSn>FS1…FSn: This sequence requires that you
take all the shots for each set to the backsight, turn to
the foresight, and then shoot all the shots for each set to
the foresight.
[BS1 FS1>FS2 BS2]n: A single set in this sequence
requires that you shoot the backsight, turn and shoot the
foresight, shoot the foresight again, turn and shoot the
backsight. Repeat for all remaining sets.
Number of Sets (n): is the number of sets you want to
shoot from each setup.
Stadia Constant: is the scale of the upper and lower
stadia (wires) in the telescope. The vertical distance
measured between these stadia multiplied by the value
entered here (usually 100) equals the horizontal distance
to the rod.
V Dist Tolerance: is the maximum change in vertical distance that
can occur between all the shots to any specific point from a single
setup. If this value is exceeded, a warning will occur.
H Dist Tolerance: is the maximum change in horizontal distance
that can occur between all the shots to any specific point from a single
setup. If this value is exceeded, a warning will occur.
; BS-FS Sight Length < Per Shot : When checked, a warning will
occur whenever the horizontal distance of each leg in any given setup
differs by more than this value.
; BS-FS Sight Length < Per Loop : When checked, the sum of the
horizontal distances measured to all the backsight shots are
compared to the sum of the horizontal distances to all the foresight
shots. If the difference exceeds this value, a warning will occur.
; Max Sight Lengths : When checked, a warning will occur
whenever the horizontal distance measured to any point exceeds this
value.