Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 261)

Survey Menu – Basic GPS Module
R-253
Base/Rover Receiver
: displays information about the status of the
receiver.
Measure To
: specifies the location on the antenna or receiver where
the antenna height should be measured to.
Measured
: The distance from the ground to the Measured To
location.
Serial #
: is the serial number of the antenna. This information is
optional and written as a note in the raw data.
Post Processing Recording Interval
: is where you set the period for
logging GPS raw data for post processing. Set it to Off to disable post
processing data collection.
Next > : opens the next screen, which depends on the type of receiver
you are connected to and at what stage in the Start GPS Survey
routine you are at.
Start Survey – One Matching Base
Point
This screen will open when the base is set up on a point
that potentially matches only one point in the job.
Change > : opens the Start Survey – No Matching Base
screen (Page R-254) where the base point can be
redefined before continuing.
Next > : opens the Set Up Rover screen.