Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 156)

Survey Pro Reference Manual
R-148
Note: After each shot is complete, the computed elevation is
displayed for the new point. You can either enter a different
elevation or tap to accept the computed elevation.
Corner & Plane
Survey Corner & Plane .
The Corner and Plane screen is used to store a point
using a reflectorless total station for a point that cannot
be shot, but three points on the same plane can be shot.
Foresight: is the name of the point that will be stored.
Description: is the description for the point that will be
stored.
HR: 0.000: shows that no rod height will be used with
this routine since all shots are direct reflectorless.
Shoot Plane : will prompt you to take three shots on the
same flat surface that the new point is located.
Note: Each shot can be in any location on the same
plane, but they must not form a straight line and they
should not be grouped close together.
Aim at Corner : will prompt you to aim at the corner (the
point that you want to store). Although no shot is taken,
the angles to the point will be used to compute its location.
Note: After all shots are done, the computed elevation is
displayed for the new point. You can either enter a
different elevation or tap to accept the computed
elevation.
Aim at target
(no shot) Shot 1 Shot 2
Shot 3
Corner & Plane