Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 202)

Survey Pro Reference Manual
R-194
Longitude
: is where you enter the WGS84 longitude for the base
point.
Ellipse
Height: is where you enter the WGS84 ellipsoid height for the
base point.
Note: You can enter latitude in dd.mmsssss format with north
positive, or you can enter dd mm ss.ssssss N/S. You can enter
longitude in ddd.mmsssssss format with east positive or you can enter
ddd mm ss.sssss E/W.
Average position for epochs before GET
: instructs the receiver to
average autonomous positions for this number of epochs before
returning.
Get Position From Receiver : queries the receiver for an autonomous
position and updates the edit boxes.
Post Processing Recording Interval
: is where you set the period for
logging GPS raw data for post processing. Set it to Off to disable post
processing data collection.
GPS Status : opens the GPS Status screen (Page R-178).
Note: It is highly recommended that you do only one autonomous
base setup per job. This will make it much easier to manage the
transformation from geodetic to local plane coordinates in your job. It
is possible, however, to do multiple autonomous setups in a job. If
you do this, each setup is assigned a unique setup group to identify
them. See the user's manual for more information on setup groups.
SET : sets the receiver as an RTK base, and configures the base
reference position in Survey Pro. If a Post Processing Recording
Interval
is selected, a file will be opened and logging of raw GPS
measurements for post processing will start. The base name and
antenna measurement will be recorded in the file for this static
session.