Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 203)

Survey Menu – GPS Module
R-195
Rover Setup
The Rover Setup screen is used to set the RTK rover receiver, and to
configure or check the base reference position in Survey Pro.
Rover Status
: displays the status of the rover setup in
Survey Pro.
Base set at
: displays the current base point. This will be
empty if the base is not set.
Detail : opens a screen that displays the geodetic
position of the base.
Antenna
: displays antenna setup for this receiver. It will
be in one of three states:
• Last Antenna for this receiver: is displayed when
you have not yet set the rover in Survey Pro. This
value is the previous antenna measurement you
used with this receiver.
• Selected
Antenna
: is displayed when you have
entered new antenna measurements using the Receiver
Antenna screen (Page R-191).
• Antenna
Set
: is displayed when you have already set the
rover in Survey Pro, and this receiver was used as the rover.
Measured
: is where you enter the height of the antenna, measured to
the location specified on the Receiver Antenna screen (Page R-191).
Offset
: displays the vertical and/or slant offset values for the selected
antenna. Entering antenna offsets is explained on the Receiver
Antenna screen, (Page R-191).
Setup HR : opens the Receiver Antenna screen (Page R-191).
Post Processing Recording Interval
: is where you set the period for
logging GPS raw data for post processing. Set it to Off to disable post
processing data collection.
Set Rover: sets the receiver as an RTK rover. If a Post Processing
Recording Interval
is selected, a file will be opened and logging of raw
GPS measurements for post processing will start. This will be a stop
and go data file, and the site ID and antenna measurement will be
recorded in the file with each point occupation at the rover