Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 201)

Survey Menu – GPS Module
R-193
Base Setup Two – SET
This final Base Setup screen is used to SET the receiver as an RTK
base using the job file point as the reference position, and to configure
the base location in Survey Pro. This screen is shown when the base
point has measured or computed geodetic coordinates in the job.
Base Point
: displays the base point name chosen in the
previous screen.
Latitude
: displays the WGS84 latitude of the job file
point.
Longitude
: displays the WGS84 longitude of the job file
point.
Ellipse
Height: displays the WGS84 height of the job file
point.
Post Processing Recording Interval
: is where you set
the period for logging GPS raw data for post processing.
Set it to Off to disable post processing data collection.
< BACK : returns to the previous Base Setup screen.
SET : sets the receiver as an RTK base, and configures the base
reference position in Survey Pro. If a Recording Interval is specified, a
file will be opened and logging of raw GPS measurements for post
processing will start. The base name and antenna measurement will
be recorded in the file for this static session.
Base Setup Two – GET and SET
This final Base Setup screen is used to GET an
autonomous (HERE) position from the receiver, SET the
receiver as an RTK base, and configure the base
reference position in Survey Pro. This screen is shown
when the selected base point does not have geodetic
coordinates.
Base Point
: displays the base point name chosen in the
previous screen.
Latitude
: is where you enter the WGS84 latitude for the
base point.