Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 120)

Survey Pro Reference Manual
R-112
Measure Mode Settings
Job Settings Measure Mode .
The Measure Mode card is used to configure the RTK data collection
settings.
Accept Solution Quality
: is where you control the
solution quality acceptable for storing measurements.
You have two options:
• Fixed RTK only: Allows storage of fixed solution
only.
• Code, Float, or Fix: Allows storage of any
differential solution.
Use Acceptance Criteria
: is where you select to apply
criteria to measurement acceptance. When checked, only
measurements with RMS and/or PDOP values below the
threshold will be accepted. To use less than all three
criteria, check this box but enter 0.0 for the criteria you
do not wish to apply.
• H RMS: is the horizontal RMS threshold for
automatic acceptance or warning on point acceptance.
• V RMS: is the vertical RMS threshold for automatic
acceptance or warning on point acceptance.
• PDOP: is the PDOP threshold for automatic acceptance or
warning on point acceptance.
Automatically Accept Data Collection:
is where you select to
automatically accept data collection points when the criteria is met.
When checked, both the data and Offset Shots screens will
automatically accept points once the measurement is better than the
specified criteria. Data collection routines will always collect at least
5 seconds worth of data before automatically accepting points based
on criteria.
Epoch Averaging
: is where you set a number of epochs to average in
Survey Pro. If this number is greater than one, Survey Pro will use
the number of epochs specified to calculate the final position using a
simple (non-weighted) average.