Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 340)

Survey Pro Reference Manual
R-332
Station Staking – Screen Two
Stakeout Station Staking Next > .
The second Station Staking screen is used to configure which Station,
Surface, and Offset you want to stake.
Use the corresponding and buttons to scroll the
available Station, Surface, and Offset that you want to
stake.
Height of Rod: is the rod height.
Backsight… : opens the Backsight Setup screen (Page R-
124) where you can set your backsight.
< Back : returns to the previous screen.
Solve > : opens the next Station Staking screen.
Station Staking – Screen
Three
Stakeout Station Staking Next > Solve > .
The third Station Staking screen shows the direction and distance
information from the instrument to the selected stake
point.
The Station, Surface, and Offset information is displayed
at the top of the screen.
From Gun to Design Point: lists the direction and
distance information used to aim the total station toward
the stake point.
Circle Zero : is used to modify the circle on the total
station so that the angle right reading will be zero when
it is facing toward the design point, which can sometimes
be easier than turning to an obscure angle value. When
this button is tapped, the following actions will occur:
1. A new backsight circle value is computed, sent to