Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 176)

Survey Pro Reference Manual
R-168
Remote Control
Survey Remote Control .
Remote control mode is a special mode that makes it easier for users
to control fully robotic total stations from a remote data collector.
Note: The remote control functions are available only after a
supported robotic total station is selected and enabled in the
Instrument Settings screen.
The Remote Control screen allows you to turn the total station in any
direction using the arrow buttons on the keypad and control the
tacking functions.
The arrow keys are typically used to get the total station to aim in the
general vicinity of the prism prior to initiating a search. The total
station will continue to turn in the direction of the button as long as
the button remains pressed.
Ï : aims the scope upward.
Ð
: aims the scope downward.
Î
: turns the scope to the right (as you face the total
station from the data collector).
Í
: turns the scope to the left.
GeoLock : This button is available when GeoLock is
enabled and when a supported total station has lost lock
on the prism. Tapping it will turn the total station to the
area of the prism computed by the GPS solution,
followed by a prism search. (See the User’s Manual for
more information on using GeoLock.)
Search : starts the search routine where the total
station searches in a specific pattern until it “sees” the prism and
then stops.
Lock : puts the total station in track mode where it will track the
movements of the prism.