Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 114)

Survey Pro Reference Manual
R-106
Modem
is selected for the Data Modem where a new data modem
configuration can be created.
Edit : Opens the Cell Phone Settings or IP Modem Settings screen
(Page R-108 or R-109, respectively) where the selected data modem
configuration can be modified.
Delete : Deletes the selected data modem configuration.
Modem Serial Comms Screen
The Modem Serial Comms. screen is used to change the settings for
communication between the base or rover receiver and the data
modem.
GPS Receiver Port
: is where you select the serial port
the receiver will use to communicate with the modem.
Baudrate
: is where you select the baud rate the receiver
will use to communicate with the modem.
Parity
: is where you select the parity the receiver will
use to communicate with the modem. This setting
disabled for receivers that do not support user defined
parity setting.
Defaults : automatically sets all the selectable values to
their defaults based on the current receiver hardware.
Receiver Set : sets the selected modem communication
settings for the specified port on the receiver.
Note: The modem communication settings are also set in the receiver
during the base and rover setup procedure. Therefore, you will not
usually have to use the Receiver Set button on this page.
Radio Settings Screen
The Radio Settings screen is used to configure settings of the base or
rover radio modem. All settings available are described below.
However, not all radios support all of the described settings, so if you
do not see one of these fields, it is because the radio type does not
support it.