Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 207)

Survey Menu – GPS Module
R-199
prompted for a new description, layer, and attribute with each
point stored.
Interval
: is where you enter the interval criteria used for continuous
collection modes. The Interval field is not available if either of the
manual methods is selected.
Update Rate
: is where you set the receiver to One Hz or Five Hz mode.
When Five Hz is selected, the receiver will compute positions five
times a second so the display will update in near real time and
measurement latency will be minimized.
Start : opens the Occupy Data Points screen (Page R-201), where
data can be collected.
Note: If you hotkey to another screen while using the Feature
Collection routine, the Feature Collection screen will be suspended
until you return to it.
Offset Shots
Survey Data Collection Offset .
The Offset Shots screen is used to collect a point you cannot
physically occupy with GPS. You can occupy a nearby point with the
GPS rover and then measure the offset distance and direction with
tape and compass, or take a shoot with a laser range finder.
Offset Point
: is the point name of the offset point to be
stored.
Description
: is the description of the offset point to be
stored.
Azimuth / Bearing : is the direction or bearing from
the occupied point to the offset point.
Direction from Two Points : is used to compute the
azimuth or bearing from the reference point to the offset
point by occupying a second reference point on line with
the offset point. Once tapped, a prompt opens for the
name to store the reference point followed by the Occupy
Data Points screen (Page R-201). After measuring the