Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 296)

Survey Pro Reference Manual
R-288
Stake to Line – Screen Two
The second screen is where the staking is performed. The graphic
display of this screen will change depending on how close the rod is to
the specified line. The initial screen, that is displayed before a shot is
performed, shows the position of the total station, the line of the
backsight and the specified line to stake. Each type of graphic is
displayed below.
Note: Tap the graphic portion of the screen for an expanded view.
HR: is the length of the rod.
EDM: This button can be
toggled to shoot in various
EDM modes. The options
available depend on the
total station being used.
Consult the total station’s
documentation for more
information on the EDM modes that it supports.
BACK / FORWARD: is the distance that the rod must
travel BACK (away from the total station) or FORWARD
(toward the total station) in order to occupy the specified
line.
LEFT of Line / RIGHT of Line / ON LINE: is displayed if
the rod is to the left or right side of the line, or is on the line. The
LEFT and RIGHT side is determined as if occupying the Start Point and
facing the Foresight Point or Direction of the line, specified in Screen
One. ON LINE is determined if you are within the Horizontal Distance
Tolerance specified in the Stakeout Settings screen (Page R-49).
Offset Dist.: is the perpendicular offset from the specified line to the
rod. This is the minimum distance that the rod must travel to occupy
the line.
Station: is the station on the specified line where the offset occurs,
relative to the Start Point.