Spectra Precision Survey Pro v4.6 Recon-Nomad Reference Manual - Manual (Page 383)

COGO Menu
R-375
Note: a boundary has two fixed sides and one side defined by a
direction when using the Hinge Method. It has one fixed side and two
sides defined by a direction when using the Parallel Method.
Editor… : accesses the Polyline Editor (Page R-66) where
a new polyline can be created or an existing polyline can
be modified.
Tap Points… : provides a map view where you can tap
any existing points to define the fixed sides of the
boundary.
To/From… : provides point selection by entering point
names.
; Store Pt 1 / 2: When checked, will store a point at the
location of the end point(s) of the computed boundary
line.
Azimuth / Bearing : defines the direction of the
boundary sides with lengths that are not yet known.
Results
Point 1 / 2: Displays the coordinate of the end points of the computed
boundary line.
Total Area: is the total area of the boundary.
Plot Area: is the area enclosed by the pre-defined fixed boundary
lines.
Difference: is the difference between the Total Area and the Plot Area.