Nematron Pointe Controller - Manual (Page 68)

Chapter 3: Quickstart Project Pointe Controller User Guide
66
3.12 Setting Breakpoints
Sometimes you’ll want to check if your program gets to a particular point in your
chart. You may also want to step through the execution of the program one
block at a time in order to debug your logic. This is achieved by setting break
points in the logic flow:
1. Make sure your program is running and Debug Trace is enabled. (See
“Monitoring Your Program” above.)
2. Select a block in the flow chart. The block will be highlighted green.
3. Click the Insert/Remove Breakpoint tool on the toolbar.