Nematron Pointe Controller - Manual (Page 239)

Pointe Controller User Guide Appendix A: OptiLogic Technical Specifications
237
Each Output point, from 0 through 7, is associated with a single Output Bit tag
(%QX).
To configure an Output, click the to the right and select an Output Bit tag
from the pop-up menu. Each tag can be used only once.
NOTE: You can leave any or all Outputs unconfigured, but if you do, those I/O
points will not be available to your project.
Failsafe tab
If, during runtime, your project fails to respond for a given timeout interval, then
the Pointe Controller unit will automatically set all Output points to
preconfigured failsafes. Parameters for this tab include:
Timeout Interval (ms) – Wait time in milliseconds after project failure
before Outputs switch to configured Output Actions.
NOTE: This value of Timeout Interval is taken from the project’s
preferences and is not editable in this window. To edit this value, see
Edit
Preferences .
Output n Action – Each Output has three possible failsafe actions:
o Fail ON – On Fail condition, turn this Output OFF.
o Fail OFF – On Fail condition, turn this Output ON.
o Last Value (default) – On Fail condition, leave this Output in its
current state.
To configure an Output Action, click the to the right and select an
action from the pop-up menu.