Nematron Pointe Controller - Manual (Page 368)

Appendix C: Ladder Diagram Block Reference Pointe Controller User Guide
366
C.3.6 Modulus (MOD)
When used in a Ladder Diagram, the MOD block finds the remainder from
dividing one input value by another input value and sends the result to output.
Select the tool (from the Math Blocks toolbar) and click on a ladder rung to
insert the following block:
Once the block is inserted, you can double-click on it to configure it.
Functional Description
This block always passes the Enable input state (EN) through to the Enable Out
output state (ENO) without change; when EN becomes on, ENO is turned on, and
when EN becomes off, ENO is turned off.
When EN becomes on, the block function is executed: Input Value 1 (IN1) is
divided by Input Value 2 (IN2) and the remainder is placed in the Output Value
(OUT).
The block function is executed every time the ladder is scanned , so long as EN
remains on. If EN becomes off, then OUT remains at its last calculated value until
EN becomes on and the block function is executed again.
Configuration Reference
The parameters of this block are described in the following table:
Param Name Config Var Type Description
EN Enable no - The state of the rung (off/on)
received from the left.
ENO Enable
Out no - The state of the rung (off/on)
passed to the right.
IN1 Input
Value 1 req any integer*
T_DONE
T_VALUE
T_PREVAL
Numeric
The first input value, which is
divided by the second input value.