Nematron Pointe Controller - Manual (Page 302)

Appendix B: Flow Chart Command Reference Pointe Controller User Guide
300
B.1.4 Clear
This command can be selected from the General commands list.
When used in a Flow Chart, the Clear command resets a specified tag to 0.
Parameters for this command include:
Tag – The tag to be reset to 0 by the command. Any Input, Memory, or
Output tag can be specified. Strings and Timers cannot be specified.
To configure the Tag parameter, click the button to open a standard
Select Tag dialog.
B.1.5 Enable and Disable
These commands can be selected from the General commands list.
When used in a Flow Chart, the Enable and Disable commands change whether a
specified Flow Chart is scanned. An enabled chart is scanned normally, while a
disabled chart is not scanned. Using these commands is equivalent to toggling the
Default State property in the specified chart’s
Start block .
Parameters for this command include:
Chart – The Flow Chart to be enabled or disabled by the command. Any
regular Flow Chart can be enabled or disabled. Ladder Diagrams, as well
as Flow Charts which have been made Subcharts, cannot be enabled or
disabled.