Nematron Pointe Controller - Manual (Page 361)

Pointe Controller User Guide Appendix C: Ladder Diagram Block Reference
359
C.3 Math Blocks
C.3.1 Add (ADD)
When used in a Ladder Diagram, the ADD block finds the sum of two inputs and
sends the result to output.
Select the tool (from the Math Blocks toolbar) and click on a ladder rung to
insert the following block:
Once the block is inserted, you can double-click on it to configure it.
Functional Description
This block always passes the Enable input state (EN) through to the Enable Out
output state (ENO) without change; when EN becomes on, ENO is turned on, and
when EN becomes off, ENO is turned off.
When EN becomes on, the block function is executed: the Input Values 1 and 2
(IN1 and IN2) are added together and the result is placed in the Output Value
(OUT).
The block function is executed every time the ladder is scanned , so long as EN
remains on. If EN becomes off, then OUT remains at its last calculated value until
EN becomes on and the block function is executed again.
Configuration Reference
The parameters of this block are described in the following table:
Param Name Config Var Type Description
EN Enable no - The state of the rung (off/on)
received from the left.
ENO Enable
Out no - The state of the rung (off/on)
passed to the right.