Nematron Pointe Controller - Manual (Page 191)

Pointe Controller User Guide Chapter 6: Downloading to the Controller
189
6.4.3 Enabling and disabling I/O
You can change the controller execution mode (i.e., whether real I/O scanning is
enabled or disabled) any time the project is stopped – for example, if you began
your debugging with I/O disabled and now want to enable it. To change the
execution mode:
1. Verify that PCM is attached to the target controller and your project is
loaded and running.
2. Click the Stop button.
3. Click the Execution mode drop-down menu and select either I / O
Enabled or I/O Disabled, as desired.
4. If you wish to restart the project from its initial state, click the Reset
button.
5. Click the Start button.