Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 39)

SierraFC M164 Protocol Analyzer User Manual 39
Easy Mode (Pre‐Defined Setups) Teledyne LeCroy
The Analysis Project dialog offers you a comprehensive set of choices to create a trigger
and capture project satisfying some specific need. You can set the Analyzer to:
 Capture specific patterns (see “Patterns and Data Capture Setup” on page 44 ).
 Capture different patterns pre‐ and post‐trigger (see “Patterns and Data Capture
Setup” on page 44 ).
 Exclude parameters from capture (see “Patterns and Data Capture Setup” on
page 44 ).
 Trigger on a pattern or sequence of patterns (see “Trigger Setup” on page 149 ).
 Configure trace capture memory (see “Project Settings” on page 180 ).
 Select file to save trace capture in memory (see “Project Settings” on page 180 ).
 Include a project note (see “Notes” on page 180 ).
Saving a Trace Capture
You can save a Trace Capture for review at a later time using the Save As dialog.
Figure 2.6: Save As Dialog