Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 157)

SierraFC M164 Protocol Analyzer User Manual 157
Easy Mode (Pre‐Defined Setups) Teledyne LeCroy
 VSAN‐ADVB
 ADVB(Object0)
 ADVB(Object2/3)
 Custom Frame
 Protocol Errors
Choosing a Parameter
Either highlight the category and click the
+>> button, or double‐click the category, to
open a corresponding definition dialog. Click on the Okay button to move the pattern to
the Active pane.
To remove an item, highlight it in the Project Tree, then click the ‐<< button.
Timers/External
Selecting a timer for a trigger in the Any Trigger Mode limits the time that the analyzer
looks for selected triggering conditions before triggering. The timer activates when the
Project runs. If none of the selected triggering conditions occurs during the timer’s active
time, the Analyzer triggers at the end of the time set for the timer.
Timer
You can set a timer independently of any other trigger selection, to cause an
unconditional trigger after a set time.
Double‐click Timer in the Pattern window to open the Add Timer Pattern dialog.
Figure 2.120: Add Timer Pattern Dialog
Check a Time Unit, enter the Timer Value, and click OK.
Note: The timer and timeout resolution is limited to one DWORD. The minimum value is 12‐13
DWORD.