Hardware setup, Connecting in general – Teledyne LeCroy SierraFC M164 User Manual User Manual

Page 17

SierraFC M164 Protocol Analyzer User Manual

Hardware Setup

Teledyne LeCroy

Hardware Setup

The hardware setup is described below.

Connecting in General

Note:

You must install the software before connecting the analyzer to the host machine for the first

time.

To set up the analyzer:

1. Connect the analyzer to a 100V–240V, 50Hz–60Hz, power outlet and turn on the

Power switch.
At power on, the analyzer will go through initialization as shown on the LCD display.

2. Connect the USB cable between the SierraFC M164 USB port and a USB port on the

host machine. The host machine operating system detects the analyzer and driver
files.
(See

for Ethernet connectivity.)

3. Connect the analyzer as shown in the following figure. The figure shows one

possible connection from an Initiator to a hard drive.

Figure 1.7: Analyzer Connections