Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 283)

SierraFC M164 Protocol Analyzer User Manual 283
Settings in Advanced Mode Teledyne LeCroy
 After the first Event has been specified you can set a Combined Event by
clicking on the link . The Events and
their descriptions are listed in
Table 4.2 on page 284 .
 After specifying an Event/Combined Event(s), click on the link add an action> to add an Action. The Actions and their descriptions are listed
in
Table 4.5 on page 294 .
Note: You can specify Events, Combined Events and Actions and additional Events. The application
automatically checks for the maximum number of terms (Events/Actions). When you exceed the
limit, an error is flagged, prompting you to jump to the place that caused the error.
Sequence and States
 Sequence: Scenarios can contain Sequences. For detailed information on
Sequences refer to
“Sequences” on page 300 .
 Click on the link to add a sequence. The State
is displayed when you add a Sequence. Double‐click on the Sequence to
open the Sequence Properties dialog to name the sequence, if desired. Dou‐
ble‐click on the State to open the State Properties dialog to name the state,
if desired.
In a Sequence you can set Events, Combined Event(s), Actions, additional Sequences
and States:
 Click on the link to add an Event. The Events
and their descriptions are listed in
Table 4.2 on page 284 .
 After the first Event has been specified you can set a Combined Event by
clicking on the link . The Events and
their descriptions are listed in
Table 4.2 on page 284 .
 After specifying an Event/Combined Event(s), click on the link add an action> to add an Action. The Actions and their descriptions are listed
in
Table 4.5 on page 294 .
Note: You can specify additional Sequences and States. The application automatically checks for the
maximum number of terms (sequences/states). When you exceed the limit, an error is flagged,
prompting you to jump to the place that caused the error.