Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 178)

Teledyne LeCroy Advanced Mode (User‐Defined)
178 SierraFC M164 Protocol Analyzer User Manual
Setting Trigger Conditions
To set the If and Else If trigger condition:
1. Click the Add Pattern button for a Pattern field and choose a trigger
condition from the drop‐down list.
Figure 2.134: Choosing a Trigger Condition
2. Define each selected pattern in the same way as in Easy Mode, as described starting
on page 47 . To use a timer, define it first.
Note: You can set a timer for any If or Else If condition.
3. Enter a value for the number of occurrences before trigger in the Cont field, up to a
maximum of 65535 occurrences.
4. Choose a capture option: Everything, Nothing, or Pattern.
5. If you choose Everything, you can select primitives for exclusion. See
“Parameters”
on page 36 .
If you choose Pattern, you can select patterns for inclusion or exclusion. See
“Defining Patterns” on page 47 .
6. Choose pattern(s) and click the +>> button to add them for capture or exclusion. You
define each pattern the same way as in Easy mode ( “Defining Patterns” on page 47 ).
7. For an output trigger, click the down arrow in the Ext. Out field and choose an
output trigger level. Note: Do not use the LOW setting in Advanced Mode.