Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 276)

Teledyne LeCroy Settings in Simple Mode
276 SierraFC M164 Protocol Analyzer User Manual
Settings in Simple Mode
The following settings can be made to create a Scenario in Simple Mode:
Settings
The following settings can be made in Simple Mode:
 Scenario Name: Give a name to the Scenario
 Jam Direction: Select From Originator or From Responder
 Repeat Jam: From the drop‐down menu select Forever, Once or Specific Count.
The default is Once.
 Repeat Count: Key in the Repeat Count in the field.
 Arm Detail: Arm Detail is explained below.
 Jam Detail: Jam Detail is explained below.
Arm Detail
Check the Arm Exists checkbox if the Arm Detail is to be set. If the Arm Exists checkbox is
checked, you can specify an Arm Event by clicking on the Event> link. The Events and their descriptions are listed in
Table 4.1 on page 277 .
An Arm Event is an Event that you want to “arm” the Jammer with. When the Jam Event
happens, the Jam Action will only happen if the Jammer was previously armed by the
Arm Event.
 Arm Rollback In: You can select Never or After Specific Duration. The default is
Never. The Arm Rollback is a timeout timer, that resets the ‘hunt’ for the Jam
Event back to the Arm Event if the specified timeout expires
 Timeout Duration: If After Specific Duration is selected, you can specify the
duration by entering a value in the fields. You can select from Seconds, MilliSec‐
onds or Microseconds.
Note: You can select “Link Speed, Both Linkup and Protocol Errors” from the Arm Events Patterns
Library since these Events are applicable only for “Arm Events”. None of these Events are
available for “Jam Events” in Simple Mode.
Jam Details
 Jam Event: Set a Jam Event by clicking on the
link. The Events and their descriptions are listed in
Table 4.1 on page 277 .
 Jam Action: Set a Jam Action by clicking on the Action> link. After the first Jam Action has been specified you can set a conse‐
quent Jam Action by clicking the [Optional]> link. The Jam Actions and their descriptions are listed in
Table 4.1 on
page 277 .
Table 4.1 on page 277 describes the Presets that can be used as Events in the Simple
Mode.