Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 184)

Teledyne LeCroy Viewer Display
184 SierraFC M164 Protocol Analyzer User Manual
You can configure the data viewer display. Toolbars are available for quick access to data
viewer display features.
You can display the same data in:
 Spreadsheet view
 Frame Inspector View
 Packet view
 Text view
 Statistical Report view
 Bus Utilization View
Note: You can change the view type when opening a sample by changing the default workspace or by
saving options in the Software Setting dialog.
Quick View
By default, the Software Settings enable Quick View. Quick View allows full access to the
whole trace more quickly, especially when using a Gigabit Ethernet connection. However,
the trace is NOT written to the host machine hard drive. To save the trace, you must
manually click Save.
If you uncheck Quick View in the Software Settings to disable Quick View, the trace loads
more slowly, but is automatically saved to the host machine hard drive. When Quick View
is disabled, the Viewer displays successive parts of trace data as they upload. As soon as a
trace part uploads, it is available in all trace views.
If you only need quick successive traces, and do not need to save them, keep the default
setting to enable Quick View.
If you need to save all captured traces, unchecking the Quick View setting loads traces
faster, especially for larger traces and slower connections than Gigabit Ethernet.
To refresh the viewer display with more uploaded data, scroll to the end of the trace,
using scroll bars, page down, arrow down, or CTRL‐End. Newly uploaded data then
appears there.
Note: High‐level decoding and statistics are available only after the whole trace has uploaded.
The software automatically switches to full trace view after trace uploading finishes.
Users must press CTRL Home to go to the beginning of an uploaded trace, and CTRL End
to go to the end of an uploaded trace.