Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 167)

SierraFC M164 Protocol Analyzer User Manual 167
Easy Mode (Pre‐Defined Setups) Teledyne LeCroy
VSAN-FCAV
VSAN- FCAV(SIMPLE)
See “VSAN‐FCAV(Simple)” on page 144 for more information.
VSAN- FCAV(EXTENDED)
See “VSAN‐FCAV(Extended)” on page 144 for more information.
VSAN-ADVB
ADVB(Object0)
See “ADVB(Object0)” on page 94 for more information.
ADVB(Object2/3)
See “ADVB(Object2/3)” on page 101 for more information.
Custom Frame
See “Custom Frame” on page 147 for more information.
Protocol Errors
See “Protocol Errors” on page 149 for more information.
Sequential Trigger Mode
In Sequential Trigger mode, triggering occurs whenever the system detects a specific
sequence of patterns. Defining the triggering patterns sets the sequence order. You must
define at least two patterns to enable selection of Sequential Trigger mode.
Note: Patterns, such as Primitives and Symbols or Frames, occurring very close together on different
ports, cause an error in triggering.
To define a triggering sequence, select more than one pattern, then check the Use
selected patterns in a sequence check box (see
Figure 2.124 on page 168 ).