Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 294)

Teledyne LeCroy Settings in Advanced Mode
294 SierraFC M164 Protocol Analyzer User Manual
1
Only shown in Action Properties dialog box when creating a sequence.
Available Resources
The list of available resources for Fibre Channel is given below:
 Symbol Detector (each has its own Embedded counter) X 4
 Ordered‐set Detector (each has its own Embedded counter) X 8
 Pattern (32bit) Detector (each has its own Embedded counter) X 12
 Training Sequence Detector X 4
 Counter X 12
 Frame Detector X 8
Link Control Disconnect Puts both FC InFusion FC ports at electrical
idle immediately. This action is only in
effect while the scenario is running, and
the Jammer will reconnect the line when
the scenario is stopped.
Reconnect Starts traffic pass‐through immediately.
This Action restarts traffic after a previous
disconnect command. Once traffic is
passing through, the originator and
responder resume link bring up.
Monitor/Count Opens a window to count the number of
Events that occur during a session. A
session is a time interval during which a
Scenario runs.
Ordered Set Jam Delete Delete an Ordered Set Jam.
Remove [Replace
with IDLE]
Remove an Ordered Set Jam or Replace
with another Ordered Set.
Replace with
another Ordered
Set
Only replace with another Ordered Set.
Restart
All Sequences
1
Restart all sequences in the Scenario.
1
Current Sequence
1 Restart the sequence that contains this
Action definition.
1
Stop Scenario Stops all Scenario activity.
Trigger Output Sends a signal out the trigger port to the
device downstream.
Analyzer Trigger The Event occurs when the Analyzer
triggers.
External Trigger
Output The Event occurs when the external Trigger
In is asserted.
Action Description