Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 290)

Teledyne LeCroy Settings in Advanced Mode
290 SierraFC M164 Protocol Analyzer User Manual
The following table lists supported Actions in Simple Mode. Note that some of these
Actions only apply to creating sequences.
TABLE 4.4: Test State Actions in Simple Mode
Action Description
Analyzer Trigger The Jammer sends a trigger to the
Analyzer.
Beep Emits audible sound of duration selectable
via a drop‐down list.
Frame Jam
Insert DWORD
Inside Frame Allows to insert up to 14 dwords inside the
frame, at the specified offset or at the
“current” dword, meaning the dword that
caused the Event.
Modify [Keep
Length] Allows to manipulate each dword in the
header, with the selected Action (click on
Pass though to get a drop‐down list).
Remove [Replace
with IDLE] Removes the whole frame.
Replace Replaces the whole frame with the
selected frame.
Truncate Removes some of the payload, as specified
in the Frame Length.
Inject General Error Invalid 10‐bit‐code
Error
Injects invalid 10b code into the line.
Running Disparity
Error Injects a Running Disparity (RD) error into
traffic.
Insert Insert DWORD Allows to insert up to 14 dwords inside the
frame, at the specified offset or at the
“current” dword, meaning the dword that
caused the Event.
Insert Frame Allows to insert a whole frame as specified
from the list of available frames.
Link Control Disconnect Puts both FC InFusion FC ports at electrical
idle immediately. This action is only in
effect while the scenario is running, and
the Jammer will reconnect the line when
the scenario is stopped.
Reconnect Starts traffic pass‐through immediately.
This Action restarts traffic after a previous
disconnect command. Once traffic is
passing through, the originator and
responder resume link bring up.