Micromod RetroPAK: SLC Configuration Manual - Manual (Page 53)

Command Series Migration to MOD 30ML
Function Codes – Gallery Tutorial
Figure 2 .20.
Inside the Loop
Compound
A loop compound is a compound or group that contains a loop block. You configure other
blocks and compounds inside the loop compound. The compound can be added to one of
the five scan groups defined in the Interface block. All the blocks inside the compound
will be executed at that scan rate.
10. Open the Loop block (LP-1) by double-clicking on it. The block will open as shown in the
next figure. We will not change anything in this block. Just notice that scan group this
compound belongs to defaults to Scan Group 1. (200 ms– refer to step 4 - Interface block).
2 - 15