Micromod RetroPAK: SLC Configuration Manual User Manual
Page 11
Command Series Migration to MOD 30ML
Function Codes – Introduction
Display Interface Block(DIF):
This block is used in MOD 30ML only. This block has configurable parameters for the
following:
• Define an instrument device tag
• Faceplate access and entry constraints (tune and configure passwords, access and entry
timeouts)
• Customize alarm/diagnostic presentation (flash/beep on/off and rates)
• Power up display
• Order in which user displays are selected by the tag key and/or
• Input for remote selection of user display
State Table Block (ST):
This block is used in MOD 30ML only. The State Table block is used by the Display
(DISP) and Process Alarm Display (PAD) blocks. The block consists of a set of tables,
each identified by a unique name. Each table contains a list of values and associated
mnemonic strings which are displayed for the corresponding value on the instrument
faceplate.
The MOD 30ML/Modcell database architecture is shown in the next figure:
1 - 3