Micromod RetroPAK: SLC Configuration Manual - Manual (Page 41)

Command Series Migration to MOD 30ML
Function Codes – Gallery Tutorial
Figure 2 .3.
New Workspace
• By default, the workspace file is created in the Project folder that is located inside the
folder where the ViZapp software is installed. For example:
C:\Program Files\ViZApp\Project.
• We will change the location for the purpose of this lab. Click on the little button next to
the Location field. This will open the Browser for Folder dialog as shown in the next
figure:
• Select the desired drive (C or D or other) from this dialog by double-clicking on it. The
next figure shows the selection of the C drive for example. See next figure:
Figure 2 .4.
Browse
2 - 3