Micromod RetroPAK: SLC Configuration Manual - Manual (Page 315)

Command Series Migration to MOD 30ML
Function Code 156 – PID (Cascade)
To change the display tag name for the PID:
Open the display block Display1 and change the Display Tag under the Display tab. See
figure below:
Figure 156c .2.
Function Code
156
Cascade PID
Display Block
The display tag name also needs to be entered into the DIF (Display Interface Block) at
the top level of the database. See the section: Procedure for adding the Display Tag to
the Display Interface Block in the chapter Introduction for more information.
156c - 5