Micromod RetroPAK: SLC Configuration Manual - Manual (Page 238)

Command Series Migration to MOD 30ML
Function Code 10 – High Select
S4 FC10 Input – S4
Floating Point Connect to the FC10.S4 signal to
the High Selector.
N FC10 Output – R
Floating Point Connect from the FC10.N output
signal from the High Selector.
APPLICATIONS
The most common use of function code 10 is to select the highest value. You can also use
this compound for finding the highest value for 2 or 3 inputs by setting a fixed value for
the unused inputs. This value can typically be zero or a negative value that is lower than
the lowest value the connected inputs can assume.
Configuration of the inputs is shown in the next figure:
Figure 10 .2.
High Select
Function Inputs
10 - 2