Micromod RetroPAK: SLC Configuration Manual - Manual (Page 13)

Command Series Migration to MOD 30ML
Function Codes – Introduction
I/O AND COMMUNICATION MODULE BLOCKS:
These blocks specify the physical I/O complement of the instrument. The following I/O
module blocks are available:
Type Function Availability
AIN Built-in universal analog input MOD 30ML
AOUT Built-in analog output MOD 30ML
VCIM Voltage or current input MOD 30ML and Modcell
TIM Thermocouple input MOD 30ML and Modcell
RIM 2 wire RTD / Resistance Input MOD 30ML and Modcell
WRIM 3 wire RTD / Resistance input MOD 30ML and Modcell
DIM Discrete input MOD 30ML and Modcell
DOM Discrete output MOD 30ML and Modcell
DDOM Double Relay output MOD 30ML and Modcell
WDOM Form-C relay output MOD 30ML and Modcell
AOM Analog Output MOD 30ML and Modcell
ICN Instrument Communication Network (Peer-to-
peer) MOD 30ML and Modcell
MSC Modcell Serial Communication (RS232, Rs485
Modbus) MOD 30ML and Modcell
RIO Remote digital interface module MOD 30ML and Modcell
RDIM Remote digital input (extended digital inputs) MOD 30ML and Modcell
RDOM Remote digital output (extended digital outputs) MOD 30ML and Modcell
FUNCTION BLOCKS
There are three types of function blocks.
Process input function blocks configure input signal conditioning, engineering unit
conversion and linearization for inputs.
Algorithm function blocks define the user configured control functions on the
instrument.
Communication function blocks handle transfer of data between groups, as well as
transfer of data to the communication interfaces.
These are shown in the next table:
1 - 5