Micromod RetroPAK: SLC Configuration Manual - Manual (Page 219)

Function Code 6 – High / Low Limiter
GENERAL DESCRIPTION
This block limits the output signal to a range that lies between a specified high and low
limit. The output equals the input when the input is between the limits. Output N
equals the high limit when the input is higher than the high limit and equals the low limit
when the input is lower than the low limit.
UTILIZATION
The MOD 30ML/MODCELL compound FC6 used here has an EX function block
(Expression block)
Figure 6 .1.
Function Code 6
The Expression block FC6 has an input called S1. The input for which High / Low limits
are applied is connected to this. The result of the EX block FC6 is the final limited result.
In the EX block FC6, enter the High Limit required in the input S2 and the Low Limit
required in input S3.
INPUTS - OUTPUTS
Signal Block Type Description
S1 FC6 Input – S1 Floating Point Connect to the FC6.S1 signal of the
compound. Input to the Limiter function.
S2 FC6 Input – S2 Floating Point Value of the High Limit
S3 FC6 Input – S3 Floating Point Value of the Low Limit
N FC6 Output – R Floating Point Connect from the FC6.N signal of the
compound. Value of the output
6 - 1