Micromod RetroPAK: SLC Configuration Manual - Manual (Page 227)

Command Series Migration to MOD 30ML
Function Code 8 – Rate Limiter
To verify this, check the execution order of the blocks. Select Objects – Set Execution
Order – List Mode from the menu bar. The Execution Order dialog will be displayed as
shown in the next figure:
Figure 8 .2.
Blocks Execution
Order
You can change the execution order of blocks by moving the blocks up or down by first
selecting the desired block and then by clicking on the Move Up or Move Down button.
Figure 8 .3.
Blocks Execution
Order after
rearranging
Click on OK after rearranging the execution order.
8 - 3