Micromod RetroPAK: SLC Configuration Manual - Manual (Page 154)

Command Series Migration to MOD 30ML
Pre-configured Dual Loop PID with Remote SP
To change the display tag name for the PID:
Open the display block PID Display inside the compound FC156 PID (PV / REMOTE
SP) in the first loop compound and change the Display Tag under the Display tab. See
figure below:
Figure P4.5.
Dual PID with
Remote SP
Display Block
The display tag name also needs to be entered into the DIF (Display Interface Block) at
the top level of the database. See the section: Procedure for adding the Display Tag to
the Display Interface Block in the chapter Introduction for more information.
Repeat this procedure for the display block PID Display inside the compound FC156 PID
(PV / REMOTE SP) in the second loop compound and change the Display Tag under the
Display tab.
P4- 8