Micromod Micro-DCI: 53SL5100A Single Loop Controller - Manual (Page 98)

Single Loop Process Controller Instruction Manual
90 Automatic/Manual Station
8.3 Automatic/Manual Station Parameter Selections
Figure 8-4 illustrates how a Single Loop Controller might appear with only the default values and power
applied, but no analog input or output signals. In Figure 8-4 , ANO0 (TB1-lO) is jumpered to ANI0 (TB1-2)
to simulate process operation. The unit has the AC power supply and power cord 173D109U03. Connect-
ing ANO0 to ANI0 is done only for illustration purposes and is not necessary to configure the controller. If
the controller is connected to a Datalink network, then assign the Instrument Address (8001) and Baud
Rate (8002) first so the remaining datapoints may be entered at the SUPERVISOR-PC unit. After this sec-
tion, refer to
Section 9 to configure the parameter display datapoints. The parameter display is accessed
by pressing the F2 push button from this display. All other datapoints not shown in the illustration are at the
default value.
Figure 8-4. CS4 Datapoint Selections