Micromod Micro-DCI: 53SL5100A Single Loop Controller - Manual (Page 18)

Single Loop Process Controller Instruction Manual
10 Installation
frames) are available in various sizes and are supplied to conform with the particular panel cut-out.
To install single or multiple mounted instruments in a prepared panel cut-out, proceed as follows.
1. Remove the through-case shipping bolt.
2. Slip the trim collar (mounting frame) over the rear of the case and slide it forward to the front of
the case.
3. Slide the instrument case through the panel opening.
a. Single mounting case - support the weight of the case and attach the top and bottom
mounting brackets. Tighten the bracket screws.
b. Multiple mounted cases - MicroMod spacer bars and self-adhesive pads must be used
between the cases, as shown in
Figure 2-3 . Start the installation from the right (when
facing the panel), installing the spacers as each case is added. Also, as each case is
positioned in place, install and tighten the top and bottom mounting brackets. Each case
must be tight against the previous case.
✎ Note
Mounting brackets and trim collars (mounting frames) are packaged
separately. Check the shipment carefully to prevent loss of
mounting hardware.
✎ Note Spacers are not required on the outside of the right and left cases.