Micromod Micro-DCI: 53SL5100A Single Loop Controller - Manual (Page 36)

Single Loop Process Controller Instruction Manual
28 Front Panel
3.3.1 Displaying a Datapoint
The following procedure illustrates how to enter EMODE and use the display function to access the con-
tents of datapoint A001 (A1). The displayed contents will be PERCENT.
Figure 3-9 and Figure 3-10 are
supporting illustrations for the display procedure which is described in Table 3-2 . It should be noted that
EMODE has a 20 second timeout if it is accessed and its functions (e.g., configure or display) are not used.
Table 3-2. Procedures to Display a Datapoint
Step Press
Shift
Result
Press to
Locate
Target
Char.
Result
1 MODE Puts instrument in EMODE.
2 If DISPLAY does not appear, press F2.
3 F3 Displays entry line: POINT .
4 ↑ A Puts A on entry line: POINT .A.
5 ← .A ∆ ↑ 1 Shifts A and puts 1 on entry line: POINT .A1.
6 F3 Enters address to display datapoint contents.
The address and the contents are displayed as
follows: A1 PERCENT.
7 MODE Returns instrument to operator mode.
Note: ∆ = space
Figure 3-9. POINT.A1